Requirements : Make sure Coin / Bill Accepter set to NO = Normally Open.

1. Coin Accepter / Bill Accepter.

2. any cheap standard 2 button Mouse.

3. 5v to 12v converter usb lead ( you can buy these from Amazon or Ebay) buy the one with screw terminal adapter included.

Connections:

1. Connect Black wire from coin accepter / Bill accepter to Negative terminal if using the adapter.

2. Connect Red Wire from coin accepter / Bill Accepter to Positive terminal if using the adapter.

3. Program your Coin accepter for how many coins and pulses,

1st coin = 1 pulse = 1 credit.

2nd coin = 2 pulses = 2 credits

etc etc.

4. Disconnect power from Coin Accepter / Bill Accepter

5. Dissasemble mouse leaving only the board with usb lead connected.

6. Look for the right mouse button microswitch on the circuit board, turn the board over and where you see the solder points for the microswitch, this is where you will solder your grey & white wires from your Coin Accepter / Bill Accepter.  Grey onside white other side.

7. go into administration for zenpoint, set coin mode to on, & credits to 1.

Final Step:

Plug Both usb connecors to the pc.

You will then have full working Coin Mode.